The 101 Association, Inc.
For the preservation and enjoyment of 1928 to 1931 Indian Scout Motocycles
"You can't wear out an Indian Scout"
 

Scout 600 timing question

  • 19 Nov 2026 4:35 AM
    Message # 13788027

    I am having trouble getting the correct timing for a late 37".

    My setup is like this,

    -Fully advanced (lever downwards) and front piston 7/32 (5,6mm) btdc.

    -points set 0,015"

    -on compression stroke front cylinder, all valves closed, narrow breaker cam comming up.

    With all timing marks aligned, the points brake at 2,7ish mm btdc. 

    Trying rotate the magneto gear 1 notch and the points brake at 9,7ish mm btcd.

    It seems the intermidiate and magneto gear is a half tooth offset.

    Did not check valve overlap nor if cam gears are 37" correct.

    Any ideas or comments are welcome.

    EDIT:I guess original pistons tdc was not flush cylinder top surface. As i am using jp pistons i dont know where i am with this as i dont know the original measurements.

    JP pistons tdc are flush with top surface cylinder, maybe 0,1 mm below.

    So i probably only can choose the 9,7mm (1 notch off)

    Last modified: 19 Nov 2026 8:35 AM | Henrik Nielsen


Copyright © 2009 The 101 Association, Inc. All rights reserved. 

Powered by Wild Apricot Membership Software